Bgwc Nevitt Forest (sc0450007)

Anderson, SC · serves 943 · Purchased surface waterSC0450007
All clear
All monitored contaminants within federal limits. Last updated from the most recent CCR and EPA monitoring data available.
See filter recommendations →
Not your system? Search your address:
Measured in your 2025 water report
From your utility's Consumer Confidence Report · 6 contaminants tested
Above limit
Approaching limit
Within limits
Regulated contaminants — legally enforceable limits
Fluoride
0.11 mg/L
Reference: MCL
Federal Maximum Contaminant Level. The legally enforceable EPA drinking-water standard.
What is it?
Naturally occurring mineral, also added to many water systems to prevent tooth decay. The MCL (4 mg/L) is much higher than the typical added amount (0.7 mg/L).
Why it matters
At levels near the MCL, long-term exposure can cause skeletal fluorosis (bone pain and tenderness). The secondary standard of 2 mg/L triggers a required public notice about dental fluorosis risk in children.
What to do
Levels below 2 mg/L are within the range considered safe. If above 2 mg/L, children under 9 may be at risk for dental fluorosis — talk to your pediatric dentist.
What the research says
Multiple peer-reviewed studies have found lower IQ in children and potential thyroid disruption at concentrations as low as 1.5 mg/L3x below the US federal limit.
Nitrate (as N)
1 mg/L
Reference: MCL
Federal Maximum Contaminant Level. The legally enforceable EPA drinking-water standard.
What is it?
Comes from fertilizer runoff, septic systems, and erosion of natural deposits. One of the most common groundwater contaminants in agricultural areas.
Why it matters
Nitrate above 10 mg/L can cause "blue baby syndrome" (methemoglobinemia) in infants under 6 months — it interferes with blood's ability to carry oxygen. Adults can tolerate higher levels.
What to do
If you have an infant on formula and your water is above 5 mg/L, consider using bottled water for formula preparation. Boiling water does NOT remove nitrate — it concentrates it.
What the research says
Multiple peer-reviewed studies have found neural tube defects, preterm birth, and low birth weight at concentrations as low as 5 mg/L2x below the US federal limit.
Lead & copper — tested at your tap
Copper
0.062 mg/L
Reference: Action level
Federal Lead and Copper Rule action level. Legally enforceable. Exceeding it triggers required corrective action by the utility.
What is it?
Leaches from copper household plumbing and pipes. Some copper is a normal part of drinking water infrastructure.
Why it matters
Short-term exposure above the action level of 1.3 mg/L can cause gastrointestinal distress. Long-term exposure can cause liver and kidney damage. At typical detected levels (well below the AL), copper is not a health concern.
What to do
If above the action level, run your tap for 30 seconds before drinking. Copper levels decrease as water flows through the pipes.
Disinfection byproducts
HAA5
20 µg/L
Reference: MCL
Federal Maximum Contaminant Level. The legally enforceable EPA drinking-water standard.
What is it?
Another group of disinfection byproducts formed when chlorine reacts with natural organic matter. HAA5 measures the five most common species.
Why it matters
Long-term exposure above the MCL of 60 µg/L (0.060 mg/L) is associated with increased cancer risk. Like THMs, the MCL is based on a running annual average.
What to do
Activated carbon filters can reduce HAA5. If your system consistently approaches the limit, a reverse osmosis filter provides more complete removal.
TTHM
31 µg/L
Reference: MCL
Federal Maximum Contaminant Level. The legally enforceable EPA drinking-water standard.
What is it?
Formed when chlorine used to disinfect water reacts with natural organic matter. Includes chloroform, bromoform, and related compounds. The trade-off: disinfection prevents waterborne disease, but creates these byproducts.
Why it matters
Long-term exposure above the MCL of 80 µg/L (0.080 mg/L) is associated with increased cancer risk and possible reproductive effects. The MCL is based on a running annual average, not a single sample.
What to do
If your system is near or above the limit, an activated carbon filter (including pitcher filters like Brita) can reduce THMs. Running water for a minute before drinking also helps, as THMs are volatile and dissipate.
Disinfectants — MRDL
Chlorine
1 mg/L
Reference: MRDL
Federal Maximum Residual Disinfectant Level. Legally enforceable EPA limit on residual disinfectant concentration in distributed water.
What is it?
Added intentionally to kill bacteria and viruses. A chlorine residual in your tap water means the disinfection is still active through the distribution system — this is by design.
Why it matters
The MRDL of 4 mg/L is the maximum allowed. Typical levels are 0.5–2 mg/L. Chlorine at normal levels is not a health concern — the disease risk from untreated water is far greater.
What to do
If you don't like the taste, let water sit in an open pitcher for 30 minutes or use an activated carbon filter. Both remove chlorine taste and odor.
% of limit

CCR data in early access — values are extracted from utility PDFs and may contain errors. Verify with your utility's 2025 CCR report.

Source: BGWC NEVITT FOREST (SC0450007) Consumer Confidence Report 2025 · Extracted by WaterScore
Measured data
Private Well Risk

Do you have or use a private well? Measured concentrations from nearby private wells sampled within 5 miles.

Details ↓
2 sites within 10 mi
Nearby Superfund Sites

2 EPA Superfund sites within 10 miles. Proximity does not necessarily mean your water is affected.

Details ↓
Blended supply
Water Sources

Anderson uses both groundwater and surface water sources, giving it more supply flexibility during drought conditions. ⚠️ This region is currently under severe drought conditions — reservoir and river levels may be reduced.

Details ↓
Spatial context
Your area on the map
Open full map →